If your gas furnace in Addison, IL is not working it is likely your furnace needs repair or service. At times the fix is simple, other times it is not. Our heating and furnace service technicians have years of experience working on furnaces like yours in Addison, IL. has service vehicles on call that are fully equipped with the tools and parts necessary to get your furnace back up and operating.
Our furnace repair, furnace service or replacement pricing is very competitive. Our estimates are always firm with no hidden surprises. You can rely on to advise you properly and to do excellent work promptly. Ask us about maintenance agreements for your high efficiency furnace today.
We provide gas furnace service in Addison, IL
We provide gas furnace repair in Addison, IL
Get Your Quote Today
Upon Arrival I Turned The Unit Sequence Of Operation Worked Until Flame Sensor Shut Down Unit. I Removed The Filter To Inspect And Discovered Filter Clogged. Client Reports Unit Blowing Cold Air, This Could Be From Clogged Filter Overheating System. Also Checked Carbon Monoxide. I Cleaned Flame Sensor And Changed Filter, I Let Unit Run For 15 Min Without Fault
Diagnosis - Dirty Flame Sensor, Clogged Filter Joyce , S. Addison , IL 12-23-2021
Upon Arrival, I Promptly Communicated With Janet Regarding The Reported Heating Issue. I Proceeded To Verify The Functionality Of The Thermostat To Ensure It Was Appropriately Signaling For Heat And Then Located The Furnace. Conducting A Comprehensive Inspection Of The Furnace And Its Wiring, I Diligently Checked For Any Potential Issues. Upon Further Investigation, I Identified A Clogged Coil At The Condenser As The Root Cause Of The Heat Pump's Overheating And Subsequent Lockout. During The Service Call, I Also Completed A Thorough Air Conditioning Preventative Maintenance Procedure As Outlined In The Checklist. Following These Steps, I Reconfigured The Thermostat, Confirming The System's Full Operational Status. Job Complete Janet , B. Addison, IL 04-26-2024
No Heat Upon Arrival, Replaced Existing Circuit Board With OEM Board And Was Able To Restore Heat Jerry, K. Addison, IL 05-17-2019
Furnace Report:
Furnace Report
• Inducer Amps MNF/ .36 - Test/.16
• Clean Flame Sensor
• Inspect Blower Motor
• Inspect Wiring
• Inspect Burner
• Inspect Orfices For Blockage
• Carbon Monoxide Test
• Inspect Chimney
• Inspect Pressure Switch Lines
• Test Sequence Of Operation
• Inspect Heat Exchanger
• Check Ignitor
• Test Gas Shut Off
• Test Thermostat For Proper Operation
Notes - Furnace Giving 275 Code (possible Faulty Gas Valve)
I Cleaned Flame Sensor To Verify Flame Not Dropping Out
Humidifier Maintenance:
Humidifier Maintenance And Cleaning
Disassemble And Inspect Aprilaire Humidifier
-Clean Drain Assembly
-Clean Distribution Tray
-Clean Water Feed Tube
-Verify Water Flow, Clean Orifice
-Clean Or Replace Drain Tube As Needed
-Verify 24v Control Operation
-Replace Media Filter
Set Manual Controls @ 35% For Winter Opperaion.
Verify Automatic Control Set In WiFi Stat William, K. Addison, IL 11-03-2021